As part of the Exploring for the Future program, whole-of-crust 3D gravity and magnetic inversion models have been produced for an area encompassing the North Australia Craton. These models were created to aid 3D geological mapping and identification of large-scale mineral systems such as those associated with iron oxide copper-gold deposits. The inversion models were derived using the University of British Columbia - Geophysical Inversion Facility MAG3D and GRAV3D programs. The inversions were constrained with geological reference models that had layers for Phanerozoic sediments, Proterozoic sediments, undifferentiated crust and the mantle. The reference model for the magnetic inversion incorporated a Curie depth surface below which magnetic susceptibility was set to zero. To allow cross-referencing, both the density and magnetic susceptibility models were designed to occupy the same physical space with identical volumes and cell sizes. A horizontal cell size of 1 km was used with 61 vertical layers, whose thickness increased with depth. The area of interest is 2450 km by 1600 km and extends to a depth of 70 km below the geoid, resulting in a total volume with ~239 million cells. Ultimately, it was not possible to invert a model of this size. Instead, the volume was broken down into a grid of overlapping tiles with 8 rows and 10 columns. Each tile was independently inverted before being recombined into a single coherent output model. When the overall model was reconstructed using the core region of each tile, some low-level edge effects were observed, increasing in significance with depth. These effects were satisfactorily attenuated by applying cosine weighting from the centre of each tile out to the edge of the overlap region during reconstruction. The coincident density and magnetic susceptibility models show a relationship with known iron oxide copper-gold deposits and regions of >2.80 g/cm3 and >0.01 SI in the Tennant Creek and Cloncurry regions. It is suggested that these regions of high-density and high-magnetic susceptibility are related to the magnetite-forming hydrothermal alteration stages of an iron oxide copper-gold deposit. The success of the NAC modelling exercise has demonstrated that this method can be expanded to produce coincident gravity and magnetic inversion models for the entire Australian region. ------------------------------------------------------------------------------------------ DOWNLOADS ------------------------------------------------------------------------------------------ Input Data: The input gravity, magnetic and elevation data (.ers and .tif). Geological Reference Models: The geological reference model as surfaces and 3D volumes (.sg, .ts, and UBCGIF). Observed vs Predicted Data: The input gravity/magnetic data compared to the predicted data (.png). Recombined Models: The recombined (cosine weighted) density and magnetic susceptibility models (.sg, and UBCGIF). Magnetite Proxies: Proxies for magnetite alteration related to IOCG deposits (.ers). Video: Video describing the method and results (.mp4).

As part of the first phase of the Exploring for the Future (EFTF) program, depth estimates have been compiled across the North Australian Craton (NAC) in the Estimates of Geological and Geophysical Surfaces (EGGS) database. These depth estimates are ultimately intended to be used to build national-scale models of Australia’s geological cover sequences. EGGS contains depth estimate points of chronostratigraphic era boundaries derived from multiple geological and geophysical datasets. This includes points from the interpretation of airborne electromagnetic (AEM) and magnetotelluric (MT) datasets, as well as from magnetic modelling. Surface and solid geology maps, and formation tops data for groundwater, petroleum and mineral boreholes are linked with the Australian Stratigraphic Units Database (ASUD) to provide chronostratigraphic context for the depth estimates. Following on from work completed across the NAC, the structure of the EGGS database has been re-designed to better enable users to extract additional key information required to build 3D models, and abide by the FAIR (Findable, Accessible, Interoperable, Reusable) data principles. For example, EGGS now identifies points associated with a significant (era-scale) chronostratigraphic unconformity – such as where the Cenozoic overlies Paleozoic or older rocks – enabling better interpolation between points in gridded cover surfaces. We are extending our EGGS coverage to the south, along the Eastern Resources Corridor, including over the Cooper Basin. Newly added data from this area includes magnetic depth estimates from targeted magnetic inversion modelling, interpretation of the AusAEM Eastern Resources Corridor survey data, and compilation of well formation tops across South Australia, Victoria and New South Wales. These data will be used to generate a 3D depth to cover model over the Eastern Resources Corridor and contribute towards building a national-scale geological architecture model. This Abstract was submitted/presented to the 2022 Central Australian Basins Symposium IV 29-30 August (https://agentur.eventsair.com/cabsiv/).

Building on newly acquired airborne electromagnetic and seismic reflection data during the Exploring for the Future (EFTF) program, Geoscience Australia (GA) generated a cover model across the Northern Territory and Queensland, in the Tennant Creek – Mount Isa (TISA) area (Figure 1; between 13.5 and 24.5⁰ S of latitude and 131.5 and 145⁰ E of longitude) (Bonnardot et al., 2020). The cover model provides depth estimates to chronostratigraphic layers, including: Base Cenozoic, Base Mesozoic, Base Paleozoic and Base Neoproterozoic. The depth estimates are based on the interpretation, compilation and integration of borehole, solid geology, reflection seismic, and airborne electromagnetic data, as well as depth to magnetic source estimates. These depth estimates in metres below the surface (relative to the Australian Height Datum) are consistently stored as points in the Estimates of Geophysical and Geological Surfaces (EGGS) database (Matthews et al., 2020). The data points compiled in this data package were extracted from the EGGS database. Preferred depth estimates were selected to ensure regional data consistency and aid the gridding. Two sets of cover depth surfaces (Bonnardot et al., 2020) were generated using different approaches to map megasequence boundaries associated with the Era unconformities: 1) Standard interpolation using a minimum-curvature gridding algorithm that provides minimum misfit where data points exist, and 2) Machine learning approach (Uncover-ML, Wilford et al., 2020) that allows to learn about relationships between datasets and therefore can provide better depth estimates in areas of sparse data points distribution and assess uncertainties. This data package includes the depth estimates data points compiled and used for gridding each surface, for the Base Cenozoic, Base Mesozoic, Base Paleozoic and Base Neoproterozoic (Figure 1). To provide indicative trends between the depth data points, regional interpolated depth surface grids are also provided for the Base Cenozoic, Base Mesozoic, Base Paleozoic and Base Neoproterozoic. The grids were generated with a standard interpolation algorithm, i.e. minimum-curvature interpolation method. Refined gridding method will be necessary to take into account uncertainties between the various datasets and variable distances between the points. These surfaces provide a framework to assess the depth and possible spatial extent of resources, including basin-hosted mineral resources, basement-hosted mineral resources, hydrocarbons and groundwater, as well as an input to economic models of the viability of potential resource development.

At its nearest, northern Australia is just over 400 km from an active convergent plate margin. This complex and unique tectonic region combines active subduction and the collision of the Sunda-Banda Arc with the Precambrian North Australian Craton (NAC) near the Timor Trough and continues through to the New Guinea Highlands. Ground-motions generated from earthquakes on these structures have particular significance for northern Australian communities and infrastructure projects, with several large earthquakes in the Banda Arc region having caused ground-shaking-related damage in the northern Australian city of Darwin over the historical period. There are very few, if any, present-day tectonic analogs where cold cratonic crust abuts a convergent tectonic margin with subduction and continent-continent collision. Ground motions recorded from earthquakes in typical subduction environments are highly attenuated as they travel through young sediments associated with forearc accretionary prisms and volcanic back-arc regions. In contrast, seismic energy from earthquakes in the northern Australian plate margin region are efficiently channelled through the low-attenuation NAC, which acts as a waveguide for high-frequency earthquake shaking. As such, it is difficult to select models appropriate to the region for seismic hazard assessments. The development of a far-field ground-motion model to support future seismic hazard assessments for northern Australia is discussed. In general, the new model predicts larger ground motions in Australia from plate margin sources than models used for the 2018 National Seismic Hazard Assessment of Australia, none of which were considered fully appropriate for the tectonic environment. Short-period ground motions are strongly dependent on hypocentral depth and are significantly higher than predictions from commonly-used intraslab ground-motion models at comparable distances. The depth dependence in ground motion diminishes with increasing spectra periods. <b>Cite this article as</b> Allen, T. I. (2021). A Far-Field Ground-Motion Model for the North Australian Craton from Plate-Margin Earthquakes, <i>Bull. Seismol. Soc. Am. </i><b> 112</b>, 1041–1059, doi: 10.1785/0120210191

The fundamental geological framework of the concealed Paleoproterozoic East Tennant area of northern Australia is very poorly understood, despite its relatively thin veneer of Phanerozoic cover and its position along strike from significant Au–Cu–Bi mineralisation of the Tennant Creek mining district within the outcropping Warramunga Province. We present 18 new U–Pb dates, obtained via Sensitive High Resolution Ion Micro Probe (SHRIMP), constraining the geological evolution of predominantly Paleoproterozoic metasedimentary and igneous rocks intersected by 10 stratigraphic holes drilled in the East Tennant area. The oldest rocks identified in the East Tennant area are two metasedimentary units with maximum depositional ages of ca. 1970 Ma and ca. 1895 Ma respectively, plus ca. 1870 Ma metagranitic gneiss. These units, which are unknown in the nearby Murphy Province and outcropping Warramunga Province, underlie widespread metasedimentary rocks of the Alroy Formation, which yield maximum depositional ages of 1873–1864 Ma. While parts of this unit appear to be correlative with the ca. 1860 Ma Warramunga Formation of the Warramunga Province, our data suggest that the bulk of the Alroy Formation in the East Tennant area is slightly older, reflecting widespread sedimentation at ca. 1870 Ma. Throughout the East Tennant area, the Alroy Formation was intruded by voluminous 1854–1845 Ma granites, contemporaneous with similar felsic magmatism in the outcropping Warramunga Province (Tennant Creek Supersuite) and Murphy Province (Nicholson Granite Complex). In contrast with the outcropping Warramunga Province, supracrustal rocks equivalent to the 1845–1810 Ma Ooradidgee Group are rare in the East Tennant area. Detrital zircon data from younger sedimentary successions corroborate seismic evidence that at least some of the thick sedimentary sequences intersected along the southern margin of the recently defined Brunette Downs rift corridor are possible age equivalents of the ca. 1670–1600 Ma Isa Superbasin. Our new results strengthen ca. 1870–1860 Ma stratigraphic and ca. 1850 Ma tectono-magmatic affinities between the East Tennant area, the Murphy Province, and the mineralised Warramunga Province around Tennant Creek, with important implications for mineral prospectivity of the East Tennant area. Appeared in Precambrian Research Volume 383, December 2022.

Australia has a significant number of surface sediment geochemical surveys that have been undertaken by industry and government over the past 50 years. These surveys represent a vast investment and have up to now only been able to be used in isolation, independently from one another. The key to maximising the full potential of these data and the information they provide for mineral exploration, environmental management and agricultural purposes is using all the surveys together, seamlessly. These disparate geochemical surveys not only sampled various landscape elements and analysed a range of size fractions, but also used multiple analytical techniques, instrument types and laboratories. The geochemical data from these surveys require levelling to eliminate, as much as possible, non-geological variation. Using a variety of methodologies, including reanalysis of both international standards and small subsets of samples from previous surveys, we have created a seamless surface geochemical map for northern Australia, from nine surveys with 15,605 samples. We tested our approach using two surveys from the southern Thomson Orogen, which demonstrated the successful removal of inter-laboratory and other analytical variation. Creation of the new combined and levelled northern Australian dataset paves the way for the application of statistical and data analytics techniques, such as principal component analysis and machine learning, thereby maximising the value of these legacy data holdings. The methodology documented here can be applied to additional geochemical datasets as they become available.

Geological maps are one of the most important datasets used in resource exploration and management. Despite increasing demand for subsurface resources such as minerals, groundwater and energy, maps of the inferred subsurface geology of Australia and other continents have been limited to small regions or jurisdictions. Here, we present the first seamless semi-continental chronostratigraphic solid geology dataset of the North Australian Craton. This dataset comprises five time slices of stratigraphic units: Cenozoic, Mesozoic, Paleozoic, Neoproterozoic and pre-Neoproterozoic. Interpretation of covered units is based on available data: surface geology and solid geology maps, magnetic intensity and gravity images, drilling logs, reflection seismic profiles and airborne electromagnetic soundings. In total, 2008 units have been mapped, all linked to the Australian Stratigraphic Units Database. So far, these maps have led to a refinement of sedimentary basin and tectonic province outlines, lessened the risks of mineral exploration through Australia’s extensive superficial cover, disclosed geological units known to host resources elsewhere, and highlighted undercover regions with poor geological constraints. <b>Citation:</b> Stewart, A.J., Liu, S.F., Bonnardot, M.-A., Highet, L.M., Woods, M., Brown, C., Czarnota, K. and Connors, K., 2020. Seamless chronostratigraphic solid geology of the North Australian Craton. In: Czarnota, K., Roach, I., Abbott, S., Haynes, M., Kositcin, N., Ray, A. and Slatter, E. (eds.) Exploring for the Future: Extended Abstracts, Geoscience Australia, Canberra, 1–4.

This web service provides access to datasets generated by the North Australian Craton (NAC) Iron Oxide Copper Gold (IOCG) Mineral Potential Assessment. Two outputs were created: a comprehensive assessment, using all available spatial data, limiting data where possible to capture mineral systems older than 1500 ma, and; a coverage assessment, which is constrained to data that have no reliance on outcrop or age of mineralisation.

This service provides Estimates of Geological and Geophysical Surfaces (EGGS). The data comes from cover thickness models based on magnetic, airborne electromagnetic and borehole measurements of the depth of stratigraphic and chronostratigraphic surfaces and boundaries.

This web service provides access to datasets generated by the North Australian Craton (NAC) Iron Oxide Copper Gold (IOCG) Mineral Potential Assessment. Two outputs were created: a comprehensive assessment, using all available spatial data, limiting data where possible to capture mineral systems older than 1500 ma, and; a coverage assessment, which is constrained to data that have no reliance on outcrop or age of mineralisation.